-Dr Rebuild's Corvette 73 350 or 454 Air Dam
Die cut sponge rubber 1" thick & 36" long, it covers the top of radiator support from fender to fender & steps down on either end. Instead of a straight path from left to right, it makes a ZIG-ZAG "W" shaped pattern. The low peak contours with the under side of the "unisex" hood found on both 350 & 454 models. Uses 2 PIF.

 Buy it Now

Part #
73 350 and 454 Radiator to Hood Air Dam


The BLUE ARROWS shown above illustrate sharp edges or corners that are found on original blueprints and the Dr REBUILD reproduction. The bogus reproduction lacks these features. Instead they have these areas radiused as curves. Since these air dams are flattened by the hood after installation, you could never used an original part to determine the correct profile. Apparently Blem Products alleged "years of research and many original samples" did not include making a die from a factory blueprint.