Rebuild's Corvette 69 L-88, 70 ZR-1, 71 LS-6, ZR-1, ZR-2
Die cut sponge rubber, 1" thick & 30" long,
with a very high peak that matches the underside of the high rise hoods
Some use 2 PIF; others none. Fat
chance you will ever see a blueprint of this at zip.
|69 L-88, 70 ZR-1, 71 LS-6, ZR-1, ZR-2 Radiator to Hood
|The BLUE ARROWS shown above illustrate sharp edges or corners that are found on
original blueprints and the Dr
REBUILD reproduction. The bogus reproduction
lacks these features. Instead they have these areas radiused as curves.
Since these air dams are flattened by the hood after installation, you could
never used an original part to determine the correct profile. Apparently
Blem Products alleged "years of research and many original samples"
did not include making a die from a factory blueprint.|