-Dr
Rebuild's Corvette 71 350 except LT-1 Air Dam- |
Die cut sponge rubber, 1" thick & 30" with the
original stepped pattern contouring with the underside of the low rise small
block hood. Uses 2 PIF. |
|
Part # |
71 350 except LT-1 Radiator to Hood Air Dam |
1274414 |
|
The BLUE ARROWS shown above illustrate sharp edges or corners that are found on
original blueprints and the Dr
REBUILD reproduction. The bogus reproduction
lacks these features. Instead they have these areas radiused as curves.
Since these air dams are flattened by the hood after installation, you could
never used an original part to determine the correct profile. Apparently
Blem Products alleged "years of research and many original samples"
did not include making a die from a factory blueprint. |
HOME |